DTF Transfer Heat Press Settings

Temperature: 312°F (160°C)
Pressure: 60 PSI
Time: 12 Seconds
Peel: Hot

For best results, pre-press your garment for 3–5 seconds to remove moisture and wrinkles before applying your transfer.

Place the transfer on the garment and press using 60 PSI pressure for 12 seconds at 312°F. After pressing, peel the film immediately while hot.

For a softer finish and better durability, perform a final press for 3–5 seconds using parchment paper or a Teflon sheet.

Tips & Tricks for Perfect DTF Transfers

1. Always Pre-Press

Moisture in garments can prevent the adhesive from bonding properly. A quick 3–5 second pre-press helps ensure a clean, even press.

2. Use Even Pressure

DTF transfers require firm, even pressure (around 60 PSI). Too little pressure can cause poor adhesion, while too much pressure can flatten the design.

3. Peel Hot

HandmadeOhio transfers are hot peel, meaning you should remove the film immediately after pressing for best results.

4. Do a Final Press

A quick 3–5 second repress with parchment paper helps lock the print into the fabric and improves durability.

5. Avoid Stretching When Hot

Allow the garment to cool briefly before stretching or folding to help the adhesive fully set.

Care Instructions

For the longest life of your garment:

• Wait 24 hours before washing

• Wash inside out

• Use cold water

• No bleach

• Tumble dry low

When applied correctly, HandmadeOhio transfers can last 25–50 washes or more without cracking or peeling.